BASIC FEATURES: Sit to Stand Lift

The content included in the video and comment section is for general information only.  Equipment and individual circumstances will vary.  

In this video, Cindy is reviewing the basic features of a Sit to Stand Lift.  There are many different brands of sit to stand lifts with potential variations in the basic features/names of the basic features. Be sure to consult with your medical equipment dealer, physical therapist, occupational therapist and/or product manual for the specific details/safety instructions for your piece of equipment.

A Sit to Stand Lift can be Electric (includes a battery pack with push button controls) or Manual/Hydraulic (includes a hydraulic hand pump) for raising and lowering the lift. This type of lift can be used for someone who is unable to assist with transfers, but can support the majority of their weight through their legs. The  client needs to have fair trunk control in sitting for use of this lift.  The sit to stand lift can be used to transfer an individual from the bed to/from a wheelchair, chair or bedside commode. 

Note

  • Always minimize the distance between the surfaces the client is being transferred to/from.
  • The Sit to Stand Lift is not and should not be used as transport device.
  • Be sure to assess the client or loved one's ability to cooperate/follow instruction prior to performing the transfer for safety. 
  • Always check the weight limit of the lift and make sure it is in good working condition prior to use.

Basic Features

  • Adjustable Base/Legs- used in widened position during lift and transfer of client or loved one
  • Shifter Handle (Adjusting Handle)- used to widen(open) and narrow(close) base of lift
  • Caster Wheels/Brakes - Do Not Apply Brakes during lifting/lowering process.  The lift needs to be allowed to move in order to position itself under the patient's center of gravity as the client is being lifted and lowered.  
  • Steering Handle/Guide Handle- area from which you push and pull the lift.
  • Pump Handle/Hydraulic Pump- pumping the handle lifts the horn/lift arms/client in the sling
  • Control Valve/Pump Valve- Closed (turn clockwise) allows you to raise the boom arm/lift by pumping handle.  Open (turn counter clockwise) allows you to lower the horns/lift arms/client in the sling, down onto sitting surface.
  • Knee Pad- typically adjustable, should rest against client's lower leg starting at 1-2 fingers width just below the knee caps 
  • Foot Plate-clients feet will be positioned on the foot plate for weight bearing surface during transfer

Special Thanks to OxyCare for use of the sit to stand lift and Sycamore Village Assisted Living, in Swansea, IL for use of your facility.

https://aecorner.video/video/iatp/basic-sit-stand